HP LaserJet M4349 Multifunction Printer series - Manual (Page 209)

4. Remove the optional duplexer or the duplex cover.
5. If you cannot see the jammed media inside the fuser, skip to step 9.
6. If you can see either the leading edge or the trailing edge of the jammed media inside the fuser,
carefully pull it out.
7. If you can see the jammed media, but neither the leading edge nor the trailing edge is visible, gently
pull on the sides of the sheet of media until one edge becomes free. Then carefully pull the jammed
media out of the fuser.
8. If the media tears as you are removing it, turn the green dial on the fuser, and then carefully pull
out the jammed media. Go to step 13.
9. To remove the fuser-entrance guide, push inward at the left edge to free the left-side alignment
pin. Then lift up slightly on the fuser-entrance guide, and remove it from the device. Place your
forefingers on the blue levers on the bottom of each side of the fuser. Place your thumbs on the
grip points on the top of each side of the fuser. Squeeze the blue levers up, and remove the fuser
from the device.
ENWW Clear jams 195