HP StorageWorks XP Remote Web Console Software - Manual (Page 76)

Setting SNMP Agent Properties 76
4-3-6 Adding Community IP Addresses
To add a community IP address:
1. Log on to open the XP Remote Web Console main pane, click Install ( ).
2. Click the SNMP IP Security tab to display the SNMP IP Security pane (see Figure 4-2).
3. Select and right-click the desired community, to display the Add Community popup menu (see Figure 4-5).
4. Click the Add IP Address command. The Add IP Address pane is displayed (see Figure 4-11).
5. In the IP Address box, enter a new IP address or select the existing IP address.
6. Click OK. The new IP address is displayed in the Community & Trap box, but the change is not yet
implemented to the subsystem.
7. If you want to apply the changes to the subsystem, click Apply. Click OK. If you want to cancel the
changes, click Cancel.
Figure 4-10 Add IP Address Pop-Up Menu
Figure 4-11 IP Address Pane