HP StorageWorks XP Remote Web Console Software - Manual (Page 71)

Setting SNMP Agent Properties 71
4-3 SNMP Agent Operations
NOTE: To set the SNMP Agent properties from the XP Remote Web Console, you must select the Extension
SNMP checkbox from the connected SVP. You must have the write permission to change the SNMP Agent
properties.
4-3-1 Adding SNMP Manager IP Addresses
To add SNMP Manager IP addresses:
1. Change to Modify mode.
2. Click Install ( ).
3. Click the SNMP IP Security tab (see Figure 4-2).
4. Enter the desired numerical IP address in the IP Address text box (see Figure 4-3).
5. Click Set to add the new IP address. The new IP address is added to the IP Address list, but the changes are
not implemented until you click Apply.
6. If you want to apply the changes to the subsystem, click Apply (or Cancel). Click OK on the confirmation
message.
Figure 4-3 Adding SNMP Manager IP Address