HP Integrity NonStop J-Series User Manual
Page 98
Pool Management
HP NonStop Storage Management Foundation User's Guide—523562-007
6-8
Example
5. Start SAFEGUARD:
>SAFECOM START SAFEGUARD
6. Stop/delete the VDP:
>SCF STOP DISK $VDP
>SCF DELETE DISK $VDP,IGNOREINCONSISTENCY
7. Remove DISK1 from the pool:
>SCF ALTER DISK $DISK1,POOL EXCLUDE
8. Remove TMF information about the existing DISK:
>TMFCOM DISABLE DATAVOL $DISK1
>TMFCOM DELETE DATAVOL $DISK1
9. Stop the disk:
>SCF STOP DISK $DISK1
10. Rename the disk:
>SCF RENAME DISK $DISK1,$DISK3
11. Add back to TMF:
>TMFCOM ADD DATAVOL $DISK3
12. Include in the pool:
>SCF ALTER DISK $DISK3,pool $Pool
13. Add the VDP again using the information collected in step 1 by the command SCF
INFO $VDP, OBEYFORM and changing $DISK1 to $DISK3.
14. Tell VDP about the new locations of the catalog:
>SCF START DISK $VDP,SPECIAL
Use the SMFIXUP USECATALOG commands:
SMFIXUP USECATALOG $VDP.ZSMSCAT.ANT $VOL.SUBVOL.FILE
SMFIXUP USECATALOG $VDP.ZSMSCAT.PENDOPS $VOL.SUBVOL.FILE
SMFIXUP USECATALOG $VDP.ZSMSCAT.IDENTITY $VOL.SUBVOL.FILE
SMFIXUP USECATALOG $VDP.ZSMSCAT.VERSION $VOL.SUBVOL.FILE
SMFIXUP USECATALOG $VDP.ZSMSCAT.DEPOBJ $VOL.SUBVOL.FILE
Note.
If SAFEGUARD is a process defined under $ZZKRN, you must abort that
process in SCF.
Note.
The IGNOREINCONSISTENCY command will prevent the deletion of the
catalog files
.