HP Integrity NonStop J-Series - Manual (Page 313)

COUP and PUP Interfaces
HP NonStop Storage Management Foundation User's Guide—523562-007
B-9
PROCESS Attribute Set
temporary file is created on the disk for use as a swap file. By default, the
operating system chooses where to place the swap file.
CPU
is the number of the primary processor in which the process should execute. By
default, the processor of the current COUP process is used.
MEMPAGES
defines the number of 1024-word memory pages to allocate for the user data
segment. By default, this value is obtained from the program object file.
PFSSIZE
is the number of kilobytes to allocate for the process file segment of the process.
By default, this value is obtained from the program object file.
TYPE
identifies the process type. The following are valid values:
When using the SET or ADD commands to define attributes for a new process, this
parameter is required.
SUBTYPE
identifies the process subtype. The following are valid values:
When using the SET or ADD commands to define attributes for a new process, this
parameter is required.
STARTUPMSG
defines the startup message to be sent to the process by COUP/DSC. Valid key-
value pairs are:
SMF Process Process Type Value
$ZSMS 52
Storage pool processes 25
Virtual disk processes 3
SMF Process Process Subtype Value
$ZSMS 0
Storage pool processes 0
Virtual disk processes 36
BC cpu-number |
CV volume-name |
MD event-mode