HP Integrity NonStop J-Series - Manual (Page 344)

COUP and PUP Interfaces
HP NonStop Storage Management Foundation User's Guide—523562-007
B-40
LISTDEV disk-or-volume-name Command
STATUS [interval]
refreshes the information values at the rate specified by the interval value,
which can range from 1 through 60 minutes. The default refresh rate is every 5
minutes.
LISTDEV DISK Command Example
LISTDEV DISK,29,DETAIL
LDEV NAME STATE PPIN PC,C,%C, %U BPIN BC,C,%C, %U D T S RSIZ
19 ?-P H 8 2,0,34, 4 8 3,0,34, 4 Y 3 29 4096
?-B H 8 2,0,24, 4 8 3,0,24, 4
20 $DATA-P * 9 2,0,24, 5 9 3,0,24, 5 Y 3 29 4096
$DATA-B 9 2,0,34, 5 9 3,0,34, 5
21 $DATA4-P * 10 2,0,34, 6 10 3,0,34, 6 Y 3 29 4096
$DATA4-B 10 2,0,24, 6 10 3,0,24, 6
<< In Pool : \IDC6.$NFCEC >>
LISTDEV disk-or-volume-name Command
The LISTDEV disk-or-volume-name command retrieves information about a
particular currently executing virtual disk or physical volume process. If a revive
operation is in progress when you issue the command, the storage pool display
appears following the revive information. The storage pool with which the virtual disk or
physical volume is associated is retrieved along with the usual LISTDEV information.
$physical-volume-name
is the name or logical device number of a physical volume.
$virtual-disk-name
is the name of a virtual disk.
DETAIL
displays more information about some devices, as described in the Peripheral
Utility Program (PUP) Reference Manual.
STATUS [interval]
refreshes the information values at the rate specified by the interval value,
which can range from 1 through 60 minutes. The default refresh rate is every 5
minutes.
LISTDEV {$physical-volume-name | $virtual-disk-name}
[,DETAIL [,STATUS [interval]]]