HP 3PAR Application Software Suite for Oracle - Manual (Page 179)

REASON
The specified Remote Copy group must be started in order to run the rmora_rsync command.
SOLUTION
Start the Remote Copy group. Refer to the HP 3PAR Remote Copy Software User's Guide for the
command syntax and usage.
MESSAGE ID
1130
SYMBOLIC NAME
RMO_ERROR_2ORMORE_ARCH_RCGROUPS
MESSAGE
3PAR1130: ERROR: Archive log volumes belong to more than one Remote Copy groups.
REASON
To support Remote Copy Software, Recovery Manager for Oracle requires the following:
•
All datafiles are in one Remote Copy group, all archive log destinations are in a second
Remote Copy group. This is a recommended group setup; or
•
All datafiles and archive log destinations belong to one Remote Copy copy.
•
If synchronous long distance Remote Copy is configured, all redo logfiles and control files
should be in separate Remote Copy groups from the datafiles and archive log destinations.
SOLUTION
Rearrange the Remote Copy groups used by the database accordingly.
MESSAGE ID
1131
SYMBOLIC NAME
RMO_ERROR_RCVV_NOTSYNCED
MESSAGE
3PAR1131: ERROR: Remote Copy volume is not currently synced.
REASON
Before using the rmore_rsync command, all of the volumes within the Remote Copy groups that
are used by the Oracle database should be in Synced status.
SOLUTION
Wait until the specified volume finishes syncing.
MESSAGE ID
1132
SYMBOLIC NAME
RMO_ERROR_RCVV_STOPPED
MESSAGE
3PAR1132: ERROR: Remote Copy volume has been stopped.
REASON
Before using the rmore_rsync command, all of the volumes within the Remote Copy groups that
are used by the Oracle database should be in Synced status.
SOLUTION
If any volumes are in Stopped status, check if the Remote Copy group has been stopped. Make
sure the Remote Copy group is in Started status.
179