NORD Drivesystems BU0550 - Manual (Page 85)

4 Frequency inverter details
BU 0550 GB-0813 85
4.1.5 Information parameters
Parameter
{Factory setting}
Setting value / Description / Note Device Supervisor
Parameter
set
P740 … [-01]
…
… [-23]
PZD bus in
(Process data Bus In)
S
0 ... FFFF (hex) This parameter informs about the actual control word and the setpoints that are transferred via
the bus systems or the PLC.
[-01] = Control word (P509) Control word, source from (P509).
[-02] = Setpoint 1 (P510 [-01]) / (P546 [-01])
[-03] = Setpoint 2 (P510 [-01]) / (P546 [-02])
[-04] = Setpoint 3 (P510 [-01]) / (P546 [-03])
[-05] = Setpoint 4 (P510 [-01]) / (P546 [-04])
[-06] = Setpoint 5 (P510 [-01]) / (P546 [-05])
Setpoint data from main setpoint (P510 [-01]).
[-07] = Resulting status In Bit P480 "Resulting status In Bit P480":The displayed
value depicts all Bus In bit sources linked with
OR.
[-08] = Parameter data In 1
[-09] = Parameter data In 2
[-10] = Parameter data In 3
[-11] = Parameter data In 4
[-12] = Parameter data In 5
Data during parameter transfer: Order label
(AK), Parameter number (PNU), Index (IND),
Parameter value (PWE 1/2).
[-13] = Setpoint 1 (P510 [-02])
[-14] = Setpoint 2 (P510 [-02])
[-15] = Setpoint 3 (P510 [-02])
[-16] = Setpoint 4 (P510 [-02])
[-17] = Setpoint 5 (P510 [-02])
Setpoint data from master function value
(Broadcast), if P509/510 = 9 or 10
(P502/P503).
[-18] = Control word PLC Control word, source PLC
[-19] = PLC setpoint 1
[-20] = PLC setpoint 2
[-21] = PLC setpoint 3
[-22] = PLC setpoint 4
[-23] = PLC setpoint 5
Setpoint data from the PLC.