West Control Solutions 8700+ - Manual (Page 57)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Page 52
P6100, P8100 & P4100 Model Group 59305, Issue 7 – March 2014
Parameter Lower
Display
Upper Display
Adjustment Range
Default
Value
When
Visible
Output 2
Cycle Time  0.5, 1, 2, 4, 8, 16, 32, 64,
128, 256 or 512 secs.
Not applicable to linear
outputs 
 
=


or
 
or

Output 3
Cycle Time  0.5, 1, 2, 4, 8, 16, 32, 64,
128, 256 or 512 secs.
Not applicable to linear
outputs   
=


or
 
or

Process High Alarm 1
value*  Range Min. to Range
Max. Range
Max.

=
 
Process Low Alarm 1
value*  Range Min. to Range
Max. Range
Min.

=
 
Deviation Alarm 1
Value* 

span from setpoint  
=
 
Band Alarm 1 value*  1 LSD to full span from
setpoint. 

=
 
Alarm 1 Hysteresis*  Up to 100% of span  Always
Process High Alarm 2
value*  Range Min. to Range
Max. Range
Max.

=
 
Process Low Alarm 2
value*  Range Min. to Range
Max. Range
Min.

=
 
Deviation Alarm 2
Value 

span from setpoint 

=
 
Band Alarm 2 value*  1 LSD to full span from
setpoint.  
=
 
Alarm 2 Hysteresis*  Up to 100% of span  Always
Loop Alarm Time*  1 sec to 99 mins. 59secs.
Only applies if primary
proportional band = 0  
=
 
Auto Pre-tune enable /
disable   disabled or

enabled
 Always
Manual Control select
enable / disable 
 disabled or

enabled
 Always
Setpoint Select shown
in Operator Mode,
enable / disable   disabled or

enabled
 Slot A or B fitted
with RSP module
Setpoint ramp shown in
operator mode, enable /
disable   disabled or

enabled
 Always
SP Ramp Rate Value  1 to 9999 units/hour or Off
(blank) Blank

Always