West Control Solutions 8700+ - Manual (Page 54)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
59305, Issue 7
– March 2014 P6100, P8100 & P4100 Model Group Page 49
Parameter Lower
Display Upper
Display Description Default
Value
When
Visible
Enable
 Read / Write. Writing via
Comms is possible
Digital Input 1
Usage   Setpoint 1 / Setpoint 2
Select**   =
 
 Automatic / Manual
Select**
Digital Input 2
Usage   Setpoint 1 / Setpoint 2
Select**   =
 
 Automatic / Manual
Select**
 Remote / Local Setpoint
Select
Remote
Setpoint Input
Range   0 to 20mA DC input  
or

=

 4 to 20mA DC input
 0 to 10V DC input
 2 to 10V DC input
 0 to 5V DC input
 1 to 5V DC input
 0 to 100mV DC input 
=


 Potentiometer (

2K

Remote
Setpoint Upper
Limit   to 
RSP value to be used when RSP input is
at maximum.
Range
max 
=

Remote
Setpoint Lower
Limit   to 
RSP value to be used when RSP input is
at minimum.
Range min 
=

Remote
Setpoint Offset  Offset applied to RSP value. Constrained
within Scale Range Upper Limit and
Scale Range Lower Limit. 
 =

Configura-
tion Mode Lock
Code     Always
*Note:
Alarm parameters marked * are repeated in Setup Mode.
**Note:
If

or

=

the remote setpoint input feature is disabled. The instrument
uses the two internal setpoints (SP1 & SP2) instead.
If

and

are set to the same value, the status of digital input 2 will take
precedence over digital input 1.