West Control Solutions 8700+ - Manual (Page 47)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Page 42
Operating and Information Modes 59305, Issue 7 – March 2014
Lock Code View
In the event that a lock code is forgotten, the instrument lock code values can be seen in the
lock code view. In this view the codes are read only, the codes can be changed from the
mode to which they apply.
Entry and Navigating in Lock Code View Mode
Press and together whilst the instrument is powering up until the

display is shown.
Once in this mode
Press to step between lock codes.
Note:
If there is no key activity for 2 minutes the instrument returns to Operator Mode. To
forcefully exit this view, switch off the instrument.
Table 10. Lock Code View Menu
Lock Code
Name Description Upper/Main
Display
Lower Display
(or 1
st
Legend)*
1
/
8
DIN
Indicator Units
Display
Configuration
Lock Code Read only view of
Configuration Lock Code. Current Value  
Setup Lock
Code Read only view of Setup
Mode Lock Code. Current Value  
Automatic
Tune Lock
Code Read only view of
Automatic Tune Lock
Code. Current Value 
*Note:
On Indicators (which have a single line display), this legend is shown for approx 1 second
before the Main display value.