Powering up, Powering up procedure, Overview of front panel – West Control Solutions 8700+ User Manual
Page 40: 5 powering up
1
/
4
-DIN,
1
/
8
-DIN &
1
/
16
- DIN Controllers & Indicators - Product Manual
59305, Issue 7
– March 2014
Powering Up
Page 35
5 Powering Up
WARNING:
ENSURE SAFE WIRING PRACTICES ARE FOLLOWED
The instrument must be powered from a supply according to the wiring label on the side of
the unit. The supply will be either 100 to 240V AC, or 24/48V AC/DC powered. Check
carefully the supply voltage and connections before applying power.
CAUTION:
When powering up for the first time, disconnect the output connections.
Powering Up Procedure
At power up, a self-test procedure is automatically started, during which all LED segments
and indicators are lit. At the first power up from new, or if the option modules are changed,
will be displayed, indicating configuration is required (refer to section 6). At all
other times, the instrument returns to operator mode once the self-test procedure is
complete.
Overview Of Front Panel
The illustration below shows a typical instrument front panel. Refer to the following table
Typical LED functions for a description of the front panel indicators. Each model in the range
will vary slightly from the example shown.
Figure 37.
Typical front panel and keys
Reset or Auto/Manual Select Key
Lower Key
Raise Key
Function Key