Alcatel-Lucent 8950 AAA - Manual (Page 98)

............................................................................................................................................................................................................................................................
Configuring Clients Configuring 8950 AAA Client Properties
5-2 365-360-001R6.0
Issue 1, December 2008
............................................................................................................................................................................................................................................................
Configuring Clients
About Configuring Clients
A RADIUS client (NAS or other resource with RADIUS client capabilities) passes session
information to designated RADIUS servers and acts on the response returned. The 8950
AAA server must have the following information for each client that sends RADIUS
requests to the server:
• IP address or domain name of the client
• A shared secret used between the server and the client
Important! Do not add entries for remote servers that will receive requests provided
from the 8950 AAA server unless requests are also received directly from this remote
server.
Using the SMT to Configure Clients
This section describes how to configure a 8950 AAA client. The specific procedure that
follows lists steps to modify an existing client using the Server Management Tool. For
information about running the SMT, please refer to
“Starting the Server Management
Tool” .
1. Select Clients/Peers from the Configuration Tools folder on the Navigation pane, as
shown in Figure 5-1 .
Figure 5-1 Navigation Pane–Clients/Peers option
Result:
The 8950 AAA client/peer panel is displayed as shown in Figure 5-2 .
The
Clients/Peers
option in the
Navigation pane