Alcatel-Lucent 8950 AAA - Manual (Page 159)

Adding Attribute Sets to Your Policy Using the 8950 AAA Policy Assistant in Server
Management Tool
............................................................................................................................................................................................................................................................
365-360-001R6.0
Issue 1, December 2008
9-19
............................................................................................................................................................................................................................................................
Adding Attribute Sets to Your Policy
About adding Attribute sets
This section covers the use of the Policy Wizard to create attribute sets and assumes that
you are creating or editing a policy and have already completed the following
configuration steps: defining a user profile source, defining an authentication source,
defining storage for accounting data, and setting session limits. You should now see the
Attribute Set for Policy panel as shown in
Figure 9-10 .
Figure 9-10 Attribute Set Panel in the Policy Wizard
If you do not want to use an attribute set with this policy, make sure the option Use
Attribute Sets is not selected and click Next to advance to the final Policy Wizard panel.
Please refer to the section
“Reviewing Your Policy” on page 25 to complete the Policy
Wizard.
Use Attribute Sets
To use attribute sets with this policy, select Use Attribute Sets. This is the default setting.
You set which attribute set is used for this policy in the Attribute to use for this Policy
frame.