Pyromation T82 - Manual (Page 9)

T82 Installation instructions
9
4.3.1 Mounting
1
2
3
4
5
6
7
9
8
1 2 3 4 5
1 2 3 4
A B
C
A0019563
å 2 Head transmitter mounting (three versions)
Item A Mounting in a terminal head (terminal head flat face as per DIN 43729)
1 Terminal head
2 Circlips
3 Insert
4 Connection wires
5 Head transmitter
6 Mounting springs
7 Mounting screws
8 Terminal head cover
9 Cable entry
Procedure mounting in a terminal head, item A:
1. Open the terminal head cover (8).
2. Guide the connection wires (4) of the insert (3) through the center hole in the head
transmitter (5).
3. Fit the mounting springs (6) on the mounting screws (7).
4. Guide the mounting screws (7) through the side boreholes of the head transmitter and the
insert (3). Then fix both mounting screws with the snap rings (2).
5. Then tighten the head transmitter (5) along with the insert (3) in the terminal head.
6. After wiring, (® ä 13) close the terminal head cover (8) back on tight.
Item B Mounting in a field housing
1 Field housing cover
2 Mounting screws with springs
3 Head transmitter