Pyromation T82 - Manual (Page 29)

T82 Diagnostics and troubleshooting
29
11.2 Diagnostics events
11.2.1 Displaying diagnostic events
1
2
1
3
A
B
A0014837
A Display in the event of a warning
B Display in the event of an alarm
1 Status signal in the header
2 The display alternates between the primary measured value and the status - indicated by the appropriate letter (M,
C or S) - plus the defined error number.
3 The display alternates between "- - - -" (no valid measured value) and the status - indicated by the appropriate
letter (F) - plus the defined error number.
Status signals
Symbol Event
category Meaning
Operating error An operating error has occurred. The measured value is no longer valid.
Maintenance
required Maintenance is required. The measured value is still valid.
Service mode The device is in service mode (e.g. during a simulation).
Out of
specification The device is being operated outside its technical specifications (e.g. during startup or a
cleaning)
Diagnostic behavior
Alarm The measurement is interrupted. The signal outputs take on the defined alarm condition.
A diagnostic message is generated (status signal F).
Warning The device continues to measure. A diagnostic message is generated (status signals M, C
or S).