Pyromation T82 - Manual (Page 6)

Basic safety instructions T82
6
2 Basic safety instructions
2.1 Requirements for the personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill the
following requirements:
► Trained, qualified specialists must have a relevant qualification for this specific function and
task
► Are authorized by the plant owner/operator
► Are familiar with federal/national regulations
► Before beginning work, the specialist staff must have read and understood the instructions in
the Operating Instructions and supplementary documentation as well as in the certificates
(depending on the application)
► Following instructions and basic conditions
The operating personnel must fulfill the following requirements:
► Being instructed and authorized according to the requirements of the task by the facility's
owner-operator
► Following the instructions in these Operating Instructions
2.2 Designated use
The device is a universal and user-configurable temperature head transmitter with either one or
two sensor inputs for a resistance thermometer (RTD), thermcouples (TC) or resistance and
voltage transmitters. The device is designed for mounting in a flat-face terminal head as per DIN
43729. Installation on a DIN rail with the optional available DIN rail clip is also possible.
The manufacturer is not liable for damage caused by improper or non-designated use.
2.3 Operational safety
► Operate the device in proper technical condition and fail-safe condition only.
► The operator is responsible for interference-free operation of the device.
Hazardous area
To eliminate a danger for persons or for the facility when the device is used in the hazardous area
(e.g. explosion protection):
► Based on the technical data on the nameplate, check whether the ordered device is permitted
for the intended use in the hazardous area. The nameplate can be found on the side of the
transmitter housing.
► Observe the specifications in the separate supplementary documentation that is an integral
part of these Instructions.
Electromagnetic compatibility
The measuring system complies with the general safety requirements in accordance with EN
61010, the EMC requirements of IEC/EN 61326 and NAMUR Recommendation NE 21 and NE
89.
NOTICE
► The unit must only be powered by a power supply that operates using an IEC 61010-1
compliant energy limited circuit, "SELV or Class 2 circuit".