KROHNE MFC 010 C Converter User Manual
Optimass
Table of contents
Document Outline
- MFC010 Interface Manual V2.3.x cover
- Blank Page
- MFC010 Interface Manual V2.3.x
- 1. Introduction
- 2. Mechanical Installation
- 3. Electrical Installation
- 4. Installation in Hazardous Area Applications
- 5. Modbus Protocol Interface
- 6. Modbus Functions Supported by the MFC010
- 6.1 01 (0116): Read Coil Status
- 6.2 02 (0216): Read Discrete Input
- 6.3 03 (0316): Read Holding Registers
- 6.4 04 (0416): Read Input Registers
- 6.5 05 (0516): Force Single Coil
- 6.6 06 (0616): Preset Single Register
- 6.7 07 (0716): Read Exception Status
- 6.8 08 (0816): Diagnostics
- 6.9 11 (0B16): Fetch Comm. Event Counter
- 6.10 16 (1016): Preset Multiple Registers
- 6.11 17 (1116): Report Slave ID
- 7. MFC010 Modbus Data Model
- 8. MFC010 Operations
- 8.1 Mass Flow Zero Calibration
- 8.2 Density Calibration
- 8.3 Fixed and Referred Density Operation
- 8.4 Concentration Measurement
- 8.5 Using the System Protection Passwords
- 8.6 Saving and Restoring Configuration settings
- 8.7 Implementing User Defined Units
- 8.8 Using the Internal Process Control Mechanism
- 8.9 Custody Transfer Applications
- 8.10 Pressure Suppression
- 9. Error and Warning Messages
- 10. Trouble Shooting
- Appendix A : Modbus CRC Checksum Calculation
- Appendix B : Hexadecimal and Binary Notation
- Appendix C : Decoding Floating Point Numbers
- Appendix D : Sensor Sizes and Associated Default Register Settings
- Appendix E : Installation of Power Supplies in MFC010 Applications
- Appendix F: MFC010 Toolbox
- Back Page