KROHNE MFC 010 C Converter - Manual (Page 36)

34
MFC010 Interface Manual
Register Description
Discrete Output (Binary) States (and Commands)
0XXXX Registers, Accessed Using Commands 01 and 05
1001 Save Changes to EEPROM
1002 Begin Zero Calibration
1003 Reset Totalisers
CT
1004 Reset Additional Totaliser
1005 Request STANDBY Mode CT
1006 Request STOP Mode CT
1007 Request MEASURE Mode
1008 Reset Errors
1009 Reset Warnings
1010 Discard Previous Write Operations
1011 Initiate Single Point Density Calibration CT
1012 Initiate Two Point Density Calibration CT
1013 Continue Two Point Density Calibration CT
1014 Reset to Factory Density Calibration CT
1015 Save Changes to EEPROM with Mass Total
1016 Save Changes to EEPROM with Volume Total
Discrete Input (Binary) States
1XXXX Registers, Accessed Using Command 02
1001 Supervisor Lock Password State
1002 Service Lock Password State
1003 Custody Transfer Lock Password State
1004 Parameters Changed, Awaiting “Save Changes to EEPROM
1005 System Error Flag
1006 Process Warning Flag
1007 Density Calibration Status
1008 Mass Flow Zero Calibration Status
1009 Process Control Status
Input Registers
3XXXX Registers, Accessed Using Command 04
Single Registers (16 bit Integer Values)
1001 Sensor A Level
1002 Sensor B Level
1003 Drive Level
1004 System State
1005 DCF1
1006 DCF5
Floating Point Values (Accessed in pairs of registers)
3001 Mass Flow
3003 Density