KEPCO BOP-GL 1KW Operator Manual Firmware Ver.3.05 and higher - Manual (Page 145)

BOP-1KW-GL 022814
B-17
B.60 [SOURce:]LIST:DWELl COMMAND
LIST:DWEL
Syntax: Short Form: LIST:DWEL (0.000093 to 0.034),,, . . . to maximum of 5900 val-
ues.
Long Form: LIST:DWELl (0.000093 to 0.034),,, . . . to maximum of 5900 val-
ues.
Description: Determines how long the main channel parameters will be active. Sets time value (from 0.000093
to 0.034) in seconds for List:Dwell locations illustrated in Table B-2. These locations are associated
with the corresponding main channel locations illustrated in Table B-2. The main channel is deter-
mined by FUNC:MODE, either current (FUNC:MODE CURR) or voltage (FUNC:MODE VOLT) If
LIST:DWEL is entered for only location 0, that time duration will apply to all steps when either
VOLT:MODE LIST or CURR:MODE LIST is executed. Related Commands: VOLT:MODE,
FUNC:MODE, LIST:CURR, LIST:VOLT, LIST:DWEL?. (See example, Figure B-5.)
B.61 [SOURce:]LIST:DWELl? QUERY
LIST:DWEL?
Syntax: Short Form: LIST:DWEL? Long Form: LIST:DWELl?
Return Value:
Description: Identifies the dwell times entered for the list. Starting at location established by LIST:QUERy,
returns comma-separated list of up to 16 values indicating the dwell time parameters entered. i.e., the
contents of LIST:DWEL locations of Table B-2. Related Commands: LIST: DWEL, LIST:QUERy. (See
example, Figure B-5.)
B.62 [SOURce:]LIST:DWELl:POINts? QUERY
LIST:DWEL:POIN?
Syntax: Short Form: LIST:DWEL:POIN? Long Form: LIST:DWELl:POINts?
Return Value: (0 to 5900)
Description:Identifies the number of locations for which time values have been entered and the next loca-
tion to be filled by a LIST:DWEL command. If LIST:DWEL:POIN? returns 6, dwell times have been
entered for locations 0 through 5 and location 6 is the next to be filled by a LIST:DWEL command.
LIST:DWEL, LIST:DWEL:POIN. (See example, Figure B-5.)
B.63 [SOURce:]LIST:QUERy COMMAND
LIST:QUER
Syntax: Short Form: LIST:QUER
Long Form: LIST:QUERy
int_value = where n = first location to be queried.
Description: Determines first location to be queried by LIST:VOLT?, LIST:CURR? or LIST:DWEL? queries.
Related Commands: LIST:VOLT?, LIST:CURR?, LIST:DWEL?. LIST:QUER?. (See example, Figure B-5.)
B.64 [SOURce:]LIST:QUERy? QUERY
LIST:QUER?
Syntax: Short Form: LIST:QUER? Long Form: LIST:QUERy?
Return Value:
Description: Identifies first location to be queried by LIST:VOLT?, LIST:CURR?, LIST:DWEL? queries.
Related Commands: LIST:QUER, LIST:CURR?, LIST:DWEL?. LIST:QUER?. (See example, Figure B-5.)