GW Instek GDS-800 Series User Manual User Manual

Page 52

GDS-800 Series Digital Storage Oscilloscope Operation Manual

PROGRAM: The advance “Program mode” function is able to let oscilloscope to

remember certain steps and replay all the saved steps. There are two main operating

classes for “Program mode”: Edit and Play. Users can edit preferred operating steps

and replay all of the saved steps afterward.

Figure 5-25: Press PROGRAM pushbutton and enter to “Program” mode

Steps Editing:

Edit: Begin to edit entire steps. Press F1 softkey again will go to replaying mode.

Step 1-15: Select the step which to be edited and rotate the VAIABLE knob to

select the preferred step. The setting of range is from 1 to 15.

Item Memory/Menu/Time: Select the conditions for each step. Press the F3

softkey continually to select three different conditions: Item Memory, Item Menu,

and Item Time.

Item Memory: Select one of the pre-saved waveform from fifteen internal

memory sets. Rotates the VARIABLE knob to pick proper memory set. The pre-

saved memory is available from memory one to memory fifteen (M1~M15).

Item Menu: Select which menu to be shown on the LCD panel for present

step running. Only two menus can be displayed during “Program Mode” running,

the two menus are measurement and cursor menu. Rotates the VARIABLE

knob to select preferred display menu.