GW Instek AFG-100/200 Series User Manual - Manual (Page 57)

OPERATION
57
Airy, Bessel, Betainc, Gamm, Legendre, Neumann
Steps 1. From the first level of the AFG
menu, press the Signal 1 Setup or
Signal 2 Setup key to select the
signal source.
2. From the bottom menu press ARB.
3. From the side menu turn ARB On.
Note
The function generator also will not allow ARB to be
turned on when sweep, burst or a modulation function
is active. Turn off any other active modes before using
ARB mode.
4. Press Load from the side menu.
5. You can load an ARB waveform from one of the
source channels, from internal memory or from
a number of predefined waveforms:
Press From to select an input
channel or internally saved
waveform.
From: CH1 ~ CH4
Ref1 ~ Ref4
Math
Wave1 ~ Wave20
Press From File to load a previously
saved waveform or a predefined
waveform.