GW Instek AFG-100/200 Series User Manual - Manual (Page 44)

AFG-125/225 Series Options Manual
44
FSK Modulation
Background The FSK Modulation function can set the hop
frequency (FSK Hop) and the frequency-shift
keying rate (FSK Rate). FSK Modulation essentially
jumps between the carrier frequency and the hop
frequency at a rate determined by the FSK rate
frequency.
Steps 1. Set the carrier waveform and
frequency. You can set the carrier
waveform and frequency in the
Selecting a Basic Waveform section.
Page 26
2. From the first level of the AFG
menu, press the Signal 1 Setup or
Signal 2 Setup key to select the
signal source.
3. From the bottom menu press
MOD.
4. From the side menu turn MOD On
and then select the FSK
modulation.
Note
Only one modulation mode can be active at any one
time. The function generator also will not allow sweep,
burst or ARB mode to be used with a modulation
function. Activating a modulation mode will turn the
previous modulation mode off.
5. Select the FSK parameters from the side menu: