Usb configuration – GW Instek AFG-100/200 Series User Manual User Manual

Page 17

Text mode
Original mode

GETTING STARTED

USB Configuration

Background

The USB Device port needs to be configured to
provide power for the AFG-125/225 if an external
power supply is not used.

Steps

1. As shown previously in the “AFG-125/225

Module Installation/Removal” section, connect
the GTL-254 USB cable.

2. Press the Utility key then I/O from

the bottom menu.

Utility

3. From the side menu press USB

Device Port and select USB Power.

The port will now supply power to the AFG-125/225.

Caution

The USB Device Port should be reconfigured to
“Computer” or “Printer” when the AFG-125/225 is not
used. Failure to do so may damage the PC or printer
when connected in the “USB Power” mode.