beautypg.com

Burst, Burst waveform – GW Instek AFG-100/200 Series User Manual User Manual

Page 53

background image

OPERATION

53

Burst

Burst Waveform

Background

The function generator can create a waveform
burst with a designated number of cycles. Burst
mode supports sine, square and ramp waveforms.

Steps

1. Set the carrier waveform and burst

frequency. You can set the carrier
waveform and burst frequency in
the Selecting a Basic Waveform
section.

Page 26

2. From the first level of the AFG

menu, press the Signal 1 Setup or
Signal 2 Setup
key to select the
signal source.

3. From the bottom menu press Burst.

4. From the side menu turn Burst On.

Note

Only one modulation mode can be active at any one
time. The function generator also will not allow sweep,
burst or ARB mode to be used with a modulation
function. Activating a modulation mode will turn the
previous modulation mode off.

5. Press N Cycle from the side menu.