GW Instek AFG-100/200 Series User Manual - Manual (Page 14)

AFG-125/225 Series Options Manual
14
DS2-FH1 Housing Installation
Background The DS2-FH1 consists of 2 housings that are
attached to the feet on the underside of the case.
Note Make sure the power is turned off before installing the
AFG-125/225 module.
Steps 1. Slip the housing over the front of the feet on the
GDS-2000A.
2. Make sure that the rear tab clips securely over
the fan vent grid on the rear panel, as shown
below.
1
2
3. The AFG-125/225 module is now ready to be
installed.