Fire-Lite MS-9050UDC Addressable Fire Alarm Control Panel - Manual (Page 140)

140 MS-9050 Series Manual — P/N 52413:G 4/14/2014
Operating Instructions Read Status
4.22.8 Program Check
Pressing 2 while viewing Read Status Screen #3 will cause a screen similar to the following to be
displayed:
Pressing 1 while viewing the Program Check screen will display a screen which will indicate if any
input zones have not been programmed to one of the Notification Appliance Circuits. Use the up
and down arrow keys to view all NACs.
Pressing 2 while viewing the Program Check screen will display a screen which will indicate if any
output zones have not been programmed to at least one input zone. Use the up and down arrow
keys to view all zones.
Pressing 3 while viewing the Program Check screen will display a screen which will indicate if any
input zones have not been programmed to at least one output zone. Use the up and down arrow
keys to view all zones.
4.22.9 History
Pressing 3 while viewing Read Status Screen #3 will display the following screen:
The operator can view all events which have been stored in the history file, only alarms or other
events, such as troubles or supervisories, by pressing the corresponding number key.
4.22.10 ANN-BUS
Pressing 1 while viewing Read Status Screen #4 will display the following screens:
Pressing 2 for Modules Installed, while viewing ANN-BUS Screen #1 will display screens with
ANN-BUS Addresses 1 through 8. Selecting an address will display information about the device
which has been assigned that address.
Pressing 3 for ANN-S/PG Options, while viewing ANN-BUS Screen #1 will display screens detail-
ing the setting for the ANN-SPG printer installed. This information includes:
• Port Parallel/Serial
• Printer Supervision Yes/No
• Off Line Timer setting
• Baud Rate
• Data Bits
• Parity
• Stop Bits
Pressing 1 for ANN-80 Options, while viewing ANN-BUS Screen #2 will display screens detailing
the settings for this device. The information includes:
• Piezo Enable/Disable
PROGRAM CHECK
1=NACS NO INPUT
2=ZONES NO INPUT
3=ZONES NO OUTPUT
HISTORY
1=VIEW ALL
2=VIEW ALARMS
3=VIEW OTHER EVENTS
ANN-BUS
ENABLED
2=MODULES INSTALLED
3=ANN-S/PG OPTIONS
ANN-BUS Screen #1
ANN-BUS
1=ANN-80 OPTIONS
2=ANN-SECONDARY
ANN-BUS Screen #2