Fire-Lite 411UDAC Communicator Dress Panel User Manual

Figure 1: mounting screws

Document #51130 Rev. B 5/10/02 P/N 51130:B

1 of 2

The communicator Dress Panel (required for Canadian
applications) can be installed to prevent accidental contact
with the AC wiring terminals and wiring connected to other
terminals. To install the Dress Panel:

As a safety precaution, it is highly recommended that all
power be removed from the main circuit board before
proceeding with installation procedure.

Remove and save the four screws and attached washers which are used to secure the four corners of the main
circuit board to the backbox mounting standoffs. Refer to Figure 1.

Install and tighten the four standoffs, which were supplied with the Dress panel, in the four corner holes which
were just vacated in step 2. Note that the male threaded end is used to resecure the main circuit board to the
backbox mounting standoffs. Refer to Figure 1.

Position the four holes in the Dress Panel over the four standoffs installed in step 3. Note that the notched
edge of the Dress Panel must be positioned to the right in order to accommodate the lock mechanism. Refer to
Figure 2.

Complete the installation by securing the Dress Panel with the four screws and attached washers which were
removed in step 2. Refer to Figure 2.

If all other installation has been completed, reapply power to the main circuit board .

EARTH AC-NEU AC-HOT

AUTIO

LTA

TB4

TB2

PH1

PH2

BATTERY

SUPV.

SYS TRBL

BATT FAULT

COMM.FAIL

AC PWR

RELAY 2

NO NC C

NAC

B+ B-

ZONE 1

B+ B-

ZONE 2

B+ B-

ZONE 4

B+ B-

ZONE 3

B+ A+ A- B-

+12V PWR

+ -

RELAY 1

NO NC C

ALARM

GND

FAULT

TB3

TB1

- +

Figure 1: Mounting Screws

ULP

.CDR

Remove All Power
(Step 1)

Remove and Retain Four
Mounting Screws From
the Corners
(Step 2)

Mounting
Screw
(Step 2)

Install Four Supplied
Standoffs in Place of
Mounting Screws
(Step 3)

Document #51130 Rev. B 05/10/02 ECN 02-255

Communicator

Dress Panel

Product Installation Drawing