Fire-Lite MS-9050UDC Addressable Fire Alarm Control Panel - Manual (Page 106)

106 MS-9050 Series Manual — P/N 52413:G 4/14/2014
Programming Master Programming Level
Onboard DACT
The Onboard DACT (Digital Alarm Communicator/Transmitter) provides communication to a cen-
tral station. Pressing 2 while viewing the Option Module Screen will cause the following screens
to be displayed:
 Onboard DACT Enable
To enable the onboard DACT, press 1 while viewing Onboard DACT Screen #1 until the display
reads Enabled Yes. The display will toggle between Enabled Yes and Enabled No with each press
of the key. The factory default setting is Enabled No.
 Primary Phone
Press 2 while viewing On Board DACT Screen #1 to program the type of primary phone line being
connected to the DACT. The following screen will be displayed:
To select the type, press 1 while viewing the Primary Phone Line screen. The following screen will
be displayed:
Press 1 to select Touchtone dialing or 2 to select Rotary dialing.
 Secondary Phone
Press 3 while viewing On Board DACT Screen #1 to program the type of secondary phone line
being connected to the DACT. The following screen will be displayed:
To select the type, press 1 while viewing the Secondary Phone Line screen. The following screen
will be displayed:
Press 1 to select Touchtone dialing or 2 to select Rotary dialing.
Ring Count
The ring count designates the number of rings allowed on the phone line prior to answering an
incoming call from a service terminal. The factory default is 0 which means the control panel will
not answer any incoming calls. This entry may be programmed for 1 to 25 rings.
OPTION MODULES
1=ANN-BUS
2=ONBOARD DACT
3=FUTURE USE
Option Module Screen
ON BOARD DACT
1=ENABLED YES
2=PRIMARY PHONE
3=SECONDARY PHONE
On Board DACT Screen #1
ON BOARD DACT
1=RING COUNT 03
2=CENTRAL STATION
3=MANUAL DIAL MODE
On Board DACT Screen #2
ON BOARD DACT
1=SUPERV PHONE LINE
On Board DACT Screen #3
ON BOARD DACT
PRIMARY PHONE LINE
1=TYPE TOUCHTONE
Primary Phone Line Screen
PHONE LINE
1=TOUCHTONE
2=ROTARY
Primary Phone Type Screen
ON BOARD DACT
1=ENABLED
2=PRIMARY PHONE
3=SECONDARY PHONE
On Board DACT Screen #1
ON BOARD DACT
SECONDARY PHONE LINE
1=TYPE TOUCHTONE
Secondary Phone Line Screen
PHONE LINE
1=TOUCHTONE
2=ROTARY
Secondary Phone Type Screen
ON BOARD DACT
1=RING COUNT
2=CENTRAL STATION
3=MANUAL DIAL MODE
On Board DACT Screen #2