Aquametrix SHARK-120/240 Controllers User Manual User Manual

Page 85

Conductivity - Utilities Menu - Meter Selection 6.6

Page 83

MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL

Conductivity - Utilities Menu - Meter Selection 6.6

DOWN

Then press
The controller will initialize itself for a
specific meter

If you do wish to initialize to this
type of meter, press the
key to highlight the Y character

If you do not wish to initialize to this
type of meter after all, then press
key to return back to the Meter
Selection menu

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

Press the key to Exit and
return to the Utilities menu

RUN MODE

Press the key to initialize the
controller as a Flow meter

Press the key to initialize the
controller as a Conductivity meter

The Meter Selection menu is used to select the meter type that the
controller is configured for, either pH, ORP, Conductivity or Flow.
Once selected, the controller will initialize itself for the selected meter's
functionality and move to run mode.

Press the key to initialize the
controller as an ORP meter

Press the key to initialize the
controller as a pH meter.

INITIALIZE? Y N

C ONDUCTIVITY

E XIT

MANUAL TEST MODE

1000uS 25.0C

UTILITIES

CALIBRATION

RELAY OVERRIDE

METER SELECTION

C ONDUCTIVITY
FLOW

EXIT

F LOW

EXIT

O RP

CONDUCTIVITY

FLOW

ORP

P H

ORP

To reset the controller back to all
the factory default values, reselect
the current meter type