Flow - utilities menu - relay override 7.3 – Aquametrix SHARK-120/240 Controllers User Manual User Manual

Page 111

Flow - Utilities Menu - Relay Override 7.3

Page 109

MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL

Flow - Utilities Menu - Relay Override 7.3

DOWN

If you wish to accept the
Override setting,
Press the key once
to move the cursor to the
RH of the display

With "N" highlighted, pressing the
key will NOT store the Override states of
the relays, but they will revert to the
state they were in before the menu was
entered. Note that, if any of the relays
were in a specific Override state before
the menu was entered (i.e. not in
AUTO), they will revert to that state
again unless the changes are STORED.

TO RELAY OVERRIDE MENU

NOT STORED

DOWN

STORED

If you do not wish to
Override Relay C, then
use the key to
the Alarm Relay

DOWN

FROM RELAY B
OVERRIDE MENU

If you wish to store the state
of the Relay Overrides,
press the key to
highlight the Y character

If you wish to Override Relay
C, Press the key once
which will move the cursor
over to the AUTO/ON/OFF text

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

Then press the key to store the
Override states of all the relays and
return back to the Override menu

NOTE
Relay C is the Alarm Relay

Then use the key
to move to the Override
setting for Relay C

DOWN

Use the or

key to

change the Override state from
AUTO - controlled by process
settings
ON - relay forced on
OFF- relay forced off
The relay will react
immediately.

DOWN

STORE? Y N

RELAY OVERRIDE

STORE? Y N

RELAY OVERRIDE

RELAY OVERRIDE
RELAY C AUTO >

RELAY OVERRIDE

RELAY C O N >

RELAY C O FF >

RELAY OVERRIDE
RELAY C A UTO >

RELAY C ON

RELAY C OFF

RELAY OVERRIDE

RELAY C AUTO

RELAY OVERRIDE