Aquametrix SHARK-120/240 Controllers User Manual - Manual (Page 28)

pH - Utilities Menu - Overfeed Timer Reset 4.7 Page 26
S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
pH - Utilities Menu - Overfeed Timer Reset 4.7
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN DOWN DOWN
If you wish to reset the overfeed timer,
then press the key to proceed
and return back to the Utilities menu.
If you do not wish to reset the
overfeed timer after all, press
the key to highlight the N
character and press the
key to return back to the Utilities
menu.
DOWN
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
RUN MODE
Press the key to
choose between Y or N.
If the control relay overfeed timer has been enabled, the relay
will “time out” after the specified overfeed time. When the
relay times out, it must be manually reset. The time out will be
signaled by the time out LED flashing on the front panel.
The reset overfeed timer will reset the timers for both relay A
& relay B at the same time.
Y N
MANUAL TEST MODE
7.15pH 25.0C
UTILITIES
CALIBRATION
RELAY OVERRIDE
METER SELECTION
RESET OVERFD TMR
RESET OVERFD TMR
Y N
RESET OVERFD TMR