Aquametrix SHARK-120/240 Controllers User Manual - Manual (Page 106)

S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Section 7 - Using the SHARK in Flow Mode
Section 7 - Using the SHARK in Flow Mode Page 104
RUN LED (GREEN)
LED WILL BE ILLUMINATED WHEN
SHARK IS IN THE RUN MODE.
WILL BE OFF WHEN SHARK IS IN
THE MENU MODE.
4 DIGIT, 7 SEGMENT LED DISPLAY
DISPLAYS PROCESS VALUE IN RUN MODE.
DISPLAYS CALIBRATION DATA IN
CALIBRATION MODE.
RELAY C (ALARM RELAY)
STATUS LED's (RED)
BOTTOM LED WILL ILLUMINATE
WHEN ALARM RELAY IS
ENERGIZED BECAUSE OF LOW
ALARM CONDITION.
TOP LED WILL ILLUMINATE WHEN
ALARM RELAY IS ENERGIZED
BECAUSE OF HIGH ALARM
BAR GRAPH LED's (GREEN)
LINEAR INDICATOR OF PROCESS
VALUE.
1/4" TURN SCREWS
RELAY A STATUS LED (YELLOW)
LED WILL BE ILLUMINATED WHEN
RELAY A IS ENERGIZED.
REMOVABLE TERMINAL BLOCK
CONNECTORS
"SNAP-ON" CONNECTORS FOR EASY
WIRING OF YOUR FLOW SENSOR
AND PRIMARY 4-20mA OUTPUT.
(REFER TO SECTIONS 3.6 & 3.12)
SIMPLE THREE-BUTTON INTERFACE
FOR FAST & EASY SETUP
(REFER TO SECTIONS 7.0 TO 7.19)
RELAY B STATUS LED (YELLOW)
LED WILL BE ILLUMINATED WHEN
RELAY B IS ENERGIZED.
UNIT LABEL
LABEL TO INDICATE UNIT OF
MEASURE SHARK IS
CONFIGURED FOR.
AUXILLARY LED's
NOT USED IN FLOW MODE.
ROLLOVER LED (RED)
LED WILL BE ILLUMINATED TO
INDICATE TOTALIZER ROLLOVER.
THE FRONT PANEL
4 PUSH BUTTONS
NOT USED IN FLOW MODE.
2 LINE, 16 CHARACTER
LCD DISPLAY
MAIN MENU INTERFACE
SCREEN
TEMPERATURE DISPLAY
NOT USED IN FLOW MODE.
GPM
P6
8 4 3 2 1 7 6 5 11 10 9 15 14 13 12 17 16
FRONT PANEL
INSIDE PANEL
NOTE
WHEN THE SHARK IS TAKEN INTO
MENU MODE VIA THE INSIDE LCD
SCREEN, THE FRONT 7-SEGMENT LED
WILL DISPLAY
----
. THE STATUS &
BAR GRAPH LED's WILL BE TURNED
OFF. THE 4 PUSH BUTTONS ON THE
FRONT WILL NOT RESPOND.