Orp - setup menu - bar graph o/r 5.13 – Aquametrix SHARK-120/240 Controllers User Manual User Manual

Page 64

ORP - Setup Menu - Bar Graph O/R 5.13

Page 62

MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL

ORP - Setup Menu - Bar Graph O/R 5.13

DOWN

Then press the key to store the
selection and return to the Bar Graph
O/R Menu.

Stored

Not stored

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

Press the key skip the
setting for the Low Green Led
and move to the setting for the
High Green Led.

With "N" selected, pressing the
key will NOT store the selection, but
simply return to theBar Graph O/R
Menu. This function is useful if you wish
to view the current selection without
making any changes.

Press the key skip the
setting for the HIgh Green Led
and move to store function.

Use the and to
adjust the setting for the High
Green Led.

Press the key to accept
the reading and move to the store
function.

Press the key once
which will move the cursor
back to the RH side.

If you wish to save the setting, press the
key to highlight the Y character

The controller displays the current
setting for the highest green Led of
the bar graph.

Press the key to accept
the reading and move to the High
Green Led setting.

Press the key once
which will move the cursor
over the least sign. digit.

Press the key once
which will move the cursor
back to the RH side.

Use the and to
adjust the setting for the Low
Green Led.

The BAR GRAPH O/R menu allows the user control
over the resolution of the bar graph on the front
panel of the Shark. The factory default for this
function is "OFF" which means the 3 green LEDS
are set to operate between the ON set points of
Relay A and B. This may not always be acceptable,
and this function allows the user to override these
settings.

The controller
displays the
current setting
for the lowest
green led of
the bar graph.

RUN MODE

Press the key
once which will move the
cursor back to the RH
side of the display.

Press the key to adjust the
resolution setting. If OFF was
selected, the menu will move to
the store function directly.

Press the key once
which will move the cursor
over the least sign. digit.

Use the and to select
the override either ON or OFF.

Press the key once
which will move the cursor
over the first character

500mV 25.0C

SETUP

UTILITIES

CALIBRATION

LOW GRN

-199 9 >

STORE? Y N

BAR GRAPH O/R

STORE? Y N

HIGH GRN

1000 >

HIGH GRN

100 0 >

BAR GRAPH O/R

BAR GRAPH O/R
HIGH GRN

1999 >

HIGH GRN

199 9 >

BAR GRAPH O/R

BAR GRAPH O/R
LOW GRN

-100 0 >

LOW GRN

-1000 >

BAR GRAPH O/R

OVERRIDE OFF >

BAR GRAPH O/R

DISPLAY DAMPING

T.DISP OVERRIDE

AUTO RETURN

TEMP SENSOR

PROBE SELECTION

TEMP UNIT

BAR GRAPH O/R

BAR GRAPH O/R
LOW GRN

-1999 >

OVERRIDE ON >

BAR GRAPH O/R

OVERRIDE O FF >

BAR GRAPH O/R

OVERRIDE O N >

BAR GRAPH O/R