Aquametrix SHARK-120/240 Controllers User Manual - Manual (Page 115)

Flow - Setup Menu - Auto Return 7.7 Page 113
S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Flow - Setup Menu - Auto Return 7.7
DOWN
Not stored
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
Stored
DOWN
DOWN
DOWN
DOWN
DOWN UP
UP DOWN
DOWN
DOWN
DOWN
UP
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
CAUTION:
If AUTO RETURN RELAYS is ON, regardless of
the user settings of the states of the relays, Relays
will default to AUTO 10 minutes after the Shark
returns to Run Mode.
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the AUTO RETURN
Selection Menu. This function is useful if
you wish to view the current selection
without making any changes.
RUN MODE
Press the key to accept the change and
move to the RELAYS auto return function.
RELAYS ON will cause the relays to return to the
AUTO mode if the controller returns to Online
after 10 minutes of inactivity. This ensures the
controller will be put back in control of the process
if accidentally left offline.
Press the key
once which will move
the cursor back to the
RH side of the display.
Press the key to
accept the change and move
to the STORE function
Then press the key to
store the selection and return
to the Auto Return Selection
Menu.
Or press the key to highlight
the Y character.
Use the or keys
to select either ON or OFF.
Press the key once
which will move the cursor to
the ON or OFF text
Press the key
once which will move
the cursor back to the
RH side of the display.
To change the MENU RETURN
setting,
Press the key once
which will move the cursor to
the ON or OFF text
Use the or keys
to select either ON or OFF. UP DOWN
MENU ON will cause the controller to exit the menu and
revert back to the online run mode after 10 minutes with no
buttons pressed. This feature ensures that if a user forgets
to return back to run mode, the controller will not be left in
an offline state. If for some reason, the user would like to
remain in the menu mode for extended periods of time, the
AUTO RETURN function can be set to "OFF".
AUTO RETURN is used to select what conditions
will cause the controller to time-out of the operations
menu, or reset the relay override function.
MENU O FF >
MENU O N >
MENU ON >
RELAYS OFF >
STORE? Y N STORE? Y N
AUTO RETURN
AUTO RETURN
TOTAL 0
SETUP
UTILITIES
CALIBRATION
AUTO RETURN AUTO RETURN
UNITS OF VOLUME
UNITS OF TIME
RELAYS ON >
AUTO RETURN
RELAYS O FF >
RELAYS O N >
AUTO RETURN
AUTO RETURN
AUTO RETURN
MENU OFF >
AUTO RETURN
AUTO RETURN
AUTO RETURN