Aquametrix SHARK-120/240 Controllers User Manual - Manual (Page 67)

S H A R K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
ORP - Diagnostics Menu - Sensor Input 5.16
ORP - Diagnostics Menu - Sensor Input 5.16 Page 65
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
The Sensor Input Menu allows the user to view real time, uncompensated
process data from the probe.
This is a Read only menu item.
The top line shows the mV input from the probe
The bottom line shows the actual value of the
temperature sensor in ohms.
Press to view the
Sensor Input data. CALIBRATION DATA
SETUP
DIAGNOSTICS
SENSOR INPUT
FIRMWARE REV.
500mV 25.0C
UTILITIES
CALIBRATION
TEMP 331 Ω >
PROBE 500mV
If the Probe is not equiped with a
Temperature Sensing Device,
and Temperature Display
Override is ON (Section 5.11),
the display will show
PROBE 500mV
TEMP O/R ON
RUN MODE