Aquametrix SHARK-120/240 Controllers User Manual - Manual (Page 2)

S H A R K
Subject Page No.
Introduction 1
Section 1 - Specifications 2
Section 2 - Installation 3 - 5
Section 3 - Electrical Connections & Setup 6 - 14
Differential Probe connection & setup 7
Combination Probe connection & setup 8
Conductivity Cell (Contacting style) connection & setup 9
Paddle Wheel Flow Sensor connection & setup 10
Relay connections 11
Relay A & B setup 12
Alarm relay setup 13
Manual test mode & Relay override 14
4-20mA Isolated Outputs Channel 1 & Channel 2 15
Service & Fuse Replacements 16
Section 4 - Using the SHARK in pH Mode 17
LCD Menu 18 - 44
LED Menu 45 - 46
Section 5 - Using the SHARK in ORP Mode 47
LCD Menu 48 - 73
LED Menu 74
Section 6 - Using the SHARK in Conductivity Mode 75
LCD Menu 76 - 102
LED Menu 103
Section 7 - Using the SHARK in Flow Mode 104
LCD Menu 105 - 128
Appendix A - Probe Configuration Table 129
Return Policy and Warranty Plan 130
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Table of Contents