Conductivity - utilities menu - relay override 6.5 – Aquametrix SHARK-120/240 Controllers User Manual User Manual

Page 84

MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL

Conductivity - Utilities Menu - Relay Override 6.5

Conductivity - Utilities Menu - Relay Override 6.5

Page 82

DOWN

If you do not wish to
Override Relay C, then
use the key to
the Alarm Relay

With "N" highlighted, pressing the
key will NOT store the Override states of
the relays, but they will revert to the
state they were in before the menu was
entered. Note that, if any of the relays
were in a specific Override state before
the menu was entered (i.e. not in
AUTO), they will revert to that state
again unless the changes are STORED.

TO RELAY
OVERRIDE MENU

NOT
STORED

FROM RELAY B
OVERRIDE MENU

Then press the key to store the
Override states of all the relays and
return back to the Override menu

STORED

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

If you wish to accept the
Override setting,
Press the key once
to move the cursor to the
RH of the display

If you wish to store the state
of the Relay Overrides,
press the key to
highlight the Y character

If you wish to Override Relay
C, Press the key
once which will move the
cursor over to the
AUTO/ON/OFF text

Then use the key
to move to the Override
setting for Relay C

NOTE
Relay C is the Alarm Relay

DOWN

Use the or key to
change the Override state from
AUTO - controlled by process
settings
ON - relay forced on
OFF- relay forced off
The relay will react
immediately.

STORE? Y N

RELAY C AUTO >

RELAY OVERRIDE

STORE? Y N

RELAY OVERRIDE

RELAY C O N >

RELAY C O FF >

RELAY OVERRIDE
RELAY C A UTO >

RELAY OVERRIDE

RELAY OVERRIDE
RELAY C ON

RELAY C OFF

RELAY OVERRIDE
RELAY C AUTO