Front panel inside panel – Aquametrix SHARK-120/240 Controllers User Manual User Manual
Page 77
Section 6 - Using the SHARK in Conductivity Mode
Page 75
S
H
A
R
K
MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL
Section 6 - Using the SHARK in Conductivity Mode
RUN LED (GREEN)
LED WILL BE ILLUMINATED WHEN
SHARK IS IN THE RUN MODE.
WILL BE OFF WHEN SHARK IS IN
THE MENU MODE.
4 DIGIT, 7 SEGMENT LED DISPLAY
DISPLAYS PROCESS VALUE IN RUN MODE.
DISPLAYS CALIBRATION DATA IN
CALIBRATION MODE.
RELAY C (ALARM RELAY)
STATUS LED's (RED)
BOTTOM LED WILL ILLUMINATE
WHEN ALARM RELAY IS
ENERGIZED BECAUSE OF LOW
ALARM CONDITION.
TOP LED WILL ILLUMINATE WHEN
ALARM RELAY IS ENERGIZED
BECAUSE OF HIGH ALARM
BAR GRAPH LED's (GREEN)
LINEAR INDICATOR OF PROCESS
VALUE.
1/4" TURN SCREWS
RELAY A STATUS LED (YELLOW)
LED WILL BE ILLUMINATED WHEN
RELAY A IS ENERGIZED.
REMOVABLE TERMINAL
BLOCK CONNECTORS
"SNAP-ON" CONNECTORS FOR
EASY WIRING OF YOUR
CONDUCTIVITY SENSORS AND
PRIMARY 4-20mA OUTPUT.
(REFER TO SECTIONS 3.5, & 3.12)
SIMPLE THREE-BUTTON INTERFACE
FOR FAST & EASY SETUP
(REFER TO SECTIONS 6.0 TO 6.21)
RELAY B STATUS LED (YELLOW)
LED WILL BE ILLUMINATED WHEN
RELAY B IS ENERGIZED.
UNIT LABEL
LABEL TO INDICATE UNIT OF
MEASURE SHARK IS
CONFIGURED FOR.
AUXILLARY LED's
NOT USED IN CONDUCTIVITY MODE.
CALIBRATION FROM THE
FRONT PANEL
4 PUSH BUTTONS USED TO
CALIBRATE THE SHARK FROM THE
FRONT PANEL.
(REFER TO SECTIONS 6.22)
2 LINE, 16 CHARACTER
LCD DISPLAY
MAIN MENU INTERFACE
SCREEN
TEMPERATURE DISPLAY
WHEN THE 'UP' AND 'DOWN' ARROW
KEYS ARE PRESSED
SIMULTANEOUSLY, THE LED WILL
DISPLAY THE CURRENT PROCESS
TEMPERATURE FOR 5 SECONDS.
THIS FEATURE WILL BE DISABLED IF
THE 'TEMPERATURE COMPENSATION
OVERRIDE' IS TURNED ON IN THE
SETUP MENU.
IN THIS CASE THE LED WILL DISPLAY
----
IN PLACE OF THE
TEMPERATURE.
uS
P6
8
4
3
2
1
7
6
5
11
10
9
15
14
13
12
17
16
FRONT PANEL
INSIDE PANEL
NOTE
WHEN THE SHARK IS TAKEN INTO
MENU MODE VIA THE INSIDE LCD
SCREEN, THE FRONT 7-SEGMENT LED
WILL DISPLAY
----
. THE STATUS &
BAR GRAPH LED's WILL BE TURNED
OFF. THE 4 PUSH BUTTONS ON THE
FRONT WILL NOT RESPOND.
OVERFEED LED (RED)
LED WILL FLASH WHEN THE
OVERFEED TIMER IS ACTIVATED.