Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual User Manual

Page 93

Stakeout Menu

Note: When

Store GPS Raw Data

on the Job/ Settings/ Measure Mode

card (Page R-8) is set to

+ Rx. Raw (

and / or

+OBN

for

Ashtech)

switching from

ROVING

OCCUPYING

will start a session in the

receiver, so you will be prompted for a point name and description.
The receiver session will be completed and the measurement stored
when you tap

6WRUH. The occupation is not stored in the Survey Pro

.RAW file if you toggle back to

ROVING.

Note: You must be within the boundary of the DTM before any cut /
fill information is provided.

' 9LHZ« : opens the 3D View screen (consult the conventional

surveying Reference manual) where a 3D view of the DTM can be
viewed from any angle as well as cut / fill information for the current
location.

Note: The

' 9LHZ« button is only available when

Generate TIN

w\Staked Points

is checked in the previous screen and at least three

stake points have been stored.

6WRUH : stores a point at the current rover location with the point

name shown in the

St Pt

field and the description in the

Desc

field.

Also advances the

St Pt

to the next available point name.

St Pt

: is the point name that will be assigned to the next stored point.

Desc

: is the description that will be assigned to the next stored point.

: is the height of the rod.

Data

: shows the northing, easting, and elevation of the current rover

location.

Result

: shows the computed elevation of the DTM at the current

location and the cut or fill necessary to bring the elevation at the
current location to the elevation of the DTM at the current location.