Store offset points – Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual User Manual
Page 91
Stakeout Menu
91
Note: When
Store GPS Raw Data
on the Job | Settings | Measure
Mode card (Page R-8) is set to
+ Rx. Raw (
and/or
+OBN
for
Ashtech)
switching from
ROVING
to
OCCUPYING
will start a session in the
receiver, so you will be prompted for a point name and description.
The receiver session will be completed and the measurement stored
when you tap
6WRUH. The occupation is not stored in the Survey Pro
.RAW file if you toggle back to
ROVING.
5HVXOWV / 1(= : displays either the results, or plane coordinates
in the lower corner of the screen.
Station
: is the station at the current rod position.
Offset Dist
: is the perpendicular distance from the line to the rod.
Elev
: is the elevation at the rod position.
Offset
: displays if the rod is on the
Left
or
Right
of the line.
Segment
: displays the type of line segment at the current station.
%DFN: returns to the previous screen.
6WRUH : stores a point for the current rod location.
Store Offset Points
6WDNHRXW 6WRUH 2IIVHW 3RLQWV
The instructions for the Store Offset Points routine for GPS are
similar to the conventional method, except that the
%DFNVLJKW button
is replaced with a
6HWXS +5 button to configure rover antenna and
the backsight information is replaced with rover antenna height
information. See the conventional Reference Manual for details.