Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 80)

GPS Reference Manual
80
Stake Points
6WDNHRXW 6WDNH 3RLQWV
The Stake Points screen in used to locate and stake out points in the
field from coordinates in the job file.
The first two screens of this routine are similar to the conventional
method, except that the
%DFNVLJKW button is replaced with a 6HWXS +5
button to configure rover antenna and the backsight information is
replaced with rover antenna height information. See the
conventional Reference Manual for details.
GPS Staking
This screen is where the measurements take place and the staking
directions are displayed. The graphic display will change depending
on how close you are to the design point. The round icon represents
the rover and the square icon represents the design point. Each
possible screen is illustrated below.
Settings : opens the Measure Mode settings (Page R-8).
GPS Status : displays the current solution type, the
number of satellites used, and the horizontal and vertical
precision computed by the receiver. When this area of
the screen is tapped, the epoch count stops and the GPS
Status screen opens (Page R-20).
Go SOUTH / NORTH : displays the distance the rover
must move in a south or north direction to reach the
design point.