Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 33)

Survey Menu – RTK
33
Manual Entry GPS
6XUYH\ &RQWURO 3RLQWV &RQWURO
The Manual GPS screen allows you to manually enter geodetic
coordinates from the Control Points and Check Points routines. You
must have your
Brand set to Manual Mode and your Model set to
Manual Entry on the Job | Settings | Receiver screen to open the
manual entry screen.
Local Coordinates: is the local plane coordinate of the
selected control or check point
Latitude : is where you enter the WGS84 latitude of the
point.
Longitude : is where you enter the WGS84 longitude of
the point.
Ellipse Height : is where you enter the WGS84 ellipsoid
height of the point.
$FFHSW : adds the WGS84 geodetic coordinates to the
plane point record and flags this point as a GPS control
point.
Check Control Point Screen
6XUYH\ &RQWURO 3RLQWV &KHFN 3RLQW
The Check Control Point screen is used to check a control point. This
is done when you want to verify the quality of the local projection
setup.
Coordinates : displays the local coordinates computed using the
current measurement and the latest projection solution.
Solution Quality : displays the quality of the current measurement:
the solution type, the number of satellites used, and the horizontal
and vertical precision computed by the receiver.