Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 30)

GPS Reference Manual
30
Note: If your antenna type is Manual, the Radius and Notch fields
will not be available
6HW : Updates the base antenna settings with the values selected on
this screen.
Note: When this screen is used by the RTK rover for updates of
antenna height during a survey, the Set button will send the new
antenna parameters to the receiver as well as updating Survey Pro's
settings.
Rover Setup
6XUYH\ 5RYHU 6HWXS
The Rover Setup screen is used to configure an RTK rover to begin
receiving differential corrections and to start the survey with the base
reference position.
Rover Status : displays the status of the rover.
Base set at : displays the current base point. This will be
empty if the base is not set.
•
Lat : displays the latitude of the base.
•
Long : displays the longitude of the base.
•
Height : displays the ellipsoid height of the base.
*(7 IURP %DVH : is used when the GPS base position is
not known to this data collector. This function will get
the base station’s geodetic coordinate over the radio link
and set the base position in Survey Pro. It will then
configure the rover receiver to start receiving differential
corrections.
6(7 5RYHU : is used when the base station was set with