Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 90)

GPS Reference Manual
90
Show Station and Offset
6WDNHRXW 6KRZ 6WDWLRQ
The Show Station and Offset routine allows you to position the rover
anywhere near a polyline, a range of points that define a line, or an
alignment to see where the rod is located in relation to the selected
line.
The first screen of this routine is similar to the conventional method,
except that the
%DFNVLJKW button is replaced with a 6HWXS +5 button
to configure rover antenna and the backsight information is replaced
with rover antenna height information. See the conventional
Reference Manual for details.
Show Station – Screen Two
Once the line is selected, the second screen is opened where
information is displayed about the rod position and the selected line.
GPS Status : displays the current solution type, the
number of satellites used, and the horizontal and vertical
precision computed by the receiver. Tap on this button
to open the detailed GPS Status screens (Page R-20).
5 Hz Mode : switches the receiver from one Hz to five Hz
mode. When this box is checked, the receiver will
compute positions five times a second so the display will
update in near real time while you are roving to the
point.
2&&83<,1* / 529,1* : switches from
ROVING to
OCCUPYING mode. When ROVING, the receiver is in
dynamic mode and will calculate your position as you
move to the point. When
OCCUPYING, the receiver is
switched to static mode (depending on settings) and will
calculate the most precise position for the staked point.