Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 26)

GPS Reference Manual
26
Base Setup One – Pick Base Point
The first Base Setup screen is used to pick the base point
and set the antenna height.
Base Point : is where you enter the point name that the
base antenna is set up over.
Note: You can enter either an existing point or a new
point name into the Base Point control. If you enter a
new point name, the routine will create a new point
record in the job file at the end of successful base station
configuration.
Antenna : displays antenna information defined from the
Base Receiver Antenna screen after tapping
6HWXS +5 .
The title of this field changes depending on if the
antenna has already been setup.
Measured : is where you enter the height of the antenna, measured to
the location specified on the Base Receiver Antenna screen.
6HWXS +5 : opens the Base Receiver Antenna screen (Page R-29)
where the details of the base antenna are defined.
Note: the antenna information and receiver serial number is stored
in the registry. When you setup the base or rover receiver and the
receiver serial number matches a number stored in the registry, the
associated antenna parameters are automatically recalled.
1H[W ! : opens the final Base Setup screen. The final screen depends
on the base point you choose:
•
If the base point has existing geodetic coordinates, or if they can
be computed from 3D plane coordinates and the latest projection
solution, the final screen allows you to SET the receiver with the
known position.