Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 15)

Job Menu
15
&RQILJXUH 0RGHP : establishes communication with the radio
firmware and opens the Radio Settings screen (Page R-15), where you
can change the radio channel and sensitivity settings.
Radio Communications Screen
-RE 6HWWLQJV 5HFHLYHU 5HFHLYHU 6HWWLQJV %DVH 0RGHP &RQILJXUH 6HULDO
-or-
-RE 6HWWLQJV 5HFHLYHU 5HFHLYHU 6HWWLQJV 5RYHU 0RGHP &RQILJXUH 6HULDO
The Radio Communications screen is used to change the settings for
communication between the base or rover receiver and the radio.
GPS Receiver Port : is where you select the serial port
the receiver will use to communicate with the radio.
Baudrate : is where you select the baud rate the receiver
will use to communicate with the radio.
Parity : When selectable, is where you select the parity
the receiver will use to communicate with the radio.
'HIDXOWV : automatically sets all the selectable values to
their defaults based on the selected hardware.
5HFHLYHU 6HW : sets the selected radio communication
settings in the receiver.
Note: The radio communication settings are also set in
the receiver during the base and rover setup procedure.
Therefore, you will not usually have to use the Receiver Set button on
this page.
Radio Settings Screen
-RE 6HWWLQJV 5HFHLYHU 5HFHLYHU 6HWWLQJV %DVH 0RGHP
&RQILJXUH 0RGHP
-or-
-RE 6HWWLQJV 5HFHLYHU 5HFHLYHU 6HWWLQJV 5RYHU 0RGHP
&RQILJXUH 0RGHP
The Radio Settings screen is used to configure settings of the base or
rover radio mode. All settings available are described below.