Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 27)

Survey Menu – RTK
27
•
If the base point does not have geodetic coordinates or if geodetic
coordinates cannot be computed for this point, the final screen is
used to GET an autonomous position and set the receiver.
Base Setup Two – SET
This final Base Setup screen is used to SET the known base position
in Survey Pro and in the receiver. This screen will open when the
base point has measured or computed geodetic coordinates in the job.
Base Point : displays the base point name chosen in the
previous screen.
Latitude : displays the current latitude for the base point.
Longitude : displays the current longitude for the base
point.
Ellipse Height : displays the current ellipsoid height for
the base point.
%$&. : returns to the previous Base Setup screen.
6(7 : sets the base position in Survey Pro and
configures the receiver to begin broadcasting differential
corrections. When successfully completed, the Current
GPS Base information screen returns with the new base
station information.