Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 35)

Survey Menu – RTK
35
Occupy Control Point Screen
6XUYH\ &RQWURO 3RLQWV &RQWURO
The Occupy Control Point screen is used to add geodetic coordinates
for a known project point. The most common use of this screen is to
measure control points for the localization solution. This screen is
also used by the Localization Calculator routine (Page R-54) for one
point localization setup.
Geodetic Coordinates : displays the geodetic coordinates
measured to the current control point.
Solution Quality : displays the quality of the current
measurement: the solution type, the number of satellites
used, and the horizontal and vertical precision computed
by the receiver.
Control Point : is where you select if the current point is
to be used for Horizontal control and/or Vertical control by
tapping the appropriate checkboxes.
Epochs : displays the number of epochs recorded since
the beginning of data collection.
Count Status : displays Measuring when we are receiving
fresh coordinates from the receiver and updating the
screen with the latest measurement.
Averaging is
displayed after you tap $FFHSW while we average the number of
epochs specified in the Epochs to Average on Accept field on the
Measure Mode Settings screen (if this value is greater than 1).
Suspended is displayed if we are not receiving valid data from the
receiver or while you are viewing a separate screen (like GPS Status).
*36 6WDWXV : stops the epoch counter and opens the GPS Status
screen (Page R-20).
$FFHSW : accepts the current control point and returns you to the
Control Points screen.