Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 60)

Survey Pro Reference Manual
R-52
descriptor for a stored stake point will automatically be set to the
point number of the design point that you are staking.
Point Tolerance: this setting affects the Remote Staking routine
(Page R-283). When performing Remote Stakeout, the final graphic
screen that is displayed when you are near the stake point will occur
when you are within the distance to the stake point specified here.
Line Tolerance: this setting affects the Stake to Line routine (Page
R-286). When staking to a line and the prism is located at a
perpendicular distance to the specified line that is within the range
set here, a message will state that you are on the line.
Horizontal Distance Tolerance: This setting affects the GPS staking
routines. When you are within the specified distance to the location
you are staking, you are considered on that location.
Turn gun to design point: only applies to motorized total stations.
The following options are available:
• 2D (HA only): A motorized total station will turn horizontally
toward the design point after tapping the Turn Gun button in
the particular stakeout screen.
• 3D (HA and ZA): A motorized total station will turn
horizontally and vertically toward the design point after
tapping the Turn Gun button in the particular stakeout
screen.
• Automatic 2D (HA only): A motorized total station will
automatically turn horizontally toward the design point when
the stakeout screen opens.
• Automatic 3D (HA and ZA): A motorized total station will
automatically turn horizontally and vertically toward the
design point when the stakeout screen opens.
Cut Sheet Offset stored: The cut sheet offset information can be
stored to the raw data file in either of the following formats when
performing any offset staking routine:
• Design
Offset
: when selected, a cut sheet report will list the
design-offset values.
• Actual
Offset
: when selected, a cut sheet report will list the
measured-offset values.